Aluminum Floor

MSRP: C$530.00  

Price: C$400.00




Aluminum floor is easy to install and light compare to wood floor.


  1. It is recommended that installation will be done by 2 people, at least at the beginning
  2. Aluminum side stringers are designed to cover joint points of floor blocks, they are not suppose to run whole length of the floor
  3. Keep sharp edges of aluminum floor away from tubes, or cover with duct or painters tape during installation
  4. Make sure tubes are fully inflated to squeeze stringers into floor channels. Boat tube should have no wrinkles or be soft to the touch.
  5. Inflate keel first, and position it such way that air valve on a top and in a middle of the keel. Then deflate keel while keeping valve in a middle of the keel. You will need it to make sure keel valve is properly position against opening in a front piece of the floor
  6. Place floor places inside boat hull such way that there is equal distances left between edges of the floor plates and edge of the boat bottom. You will need these spaces to install stringers
Insert stringers into side edges of floorboards. Side edges of floorboard should easily fit into C-channel of stringer.
Top View Bottom View Correct stringer position


Inflate boat about 20% and insert front bow section of the floor
Insert  second and last sections of the floor
Two middle sections will create roof-like structure
Step on raised part of two connected floor sections
Make sure that floor will flatten by spreading inside the boat
Insert aluminum stringers between boat tubes and floor sections
Aluminum stringers should interconnect at least two sections of the floor
Inflate left and right tube of the boat. Use hand pump to finish
Inflate bow section of the boat. Use hand pump to finish

Last step is to inflate keel of the boat with a hand pump

Technical specs


Be the first to write a review

Write a review:

Type the characters you see in the picture below.